Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. (2) this device must accept any interference received, including interference that may cause undesired operation. (1) this device may not cause harmful interference, and Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. UKCA RF Output table (The Radio Equipment Regulations 2017) Function Frequency E-Field strength (at 10 m) Active stylus 18-210 KHz -11.73 dBuA/mįEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT EQUIPMENT AUTHORIZATION REQUIREMENT.ĭevices operating below 490 kHz in which all emissions are at least 40 dB below the limits in §15.209 shall be verified pursuant to the procedures in Subpart J of part 2 of this chapter prior to marketing. HEJ STYLUS 2.0 FULLFull text of UKCA declaration of conformity is available at. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of The Radio Equipment Regulations 2017 (S.I. Simplified UKCA Declaration of ConformityĪSUSTek Computer Inc. ĬE RED RF Output table (Directive 2014/53/EU) Function Frequency E-Field strength (at 10 m) Active stylus 18-210 KHz -11.73 dBuA/m Full text of EU declaration of conformity available at. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. Choose the pen tip you wish to replace, then align and fit the new pen tip.ĪSUSTeK Computer Inc. Ensure the slot is positioned between the pen tip and the pen, then pull your ASUS pen vertically and remove the pen tip.ĭ. Hold your ASUS pen vertically, then align and slide the current pen tip into the narrow slot.Ĭ. Locate the teardrop-shaped slot on the packaging tray.ī. The LED indicator will turn white once the pairing process is complete.Ī. HEJ STYLUS 2.0 BLUETOOTHOn the other device, select “ASUS Pen” from the Bluetooth device list to start pairing.ĭ. Press and hold the Bluetooth button on your ASUS Pen until the LED indicator starts blinking blue light.Ĭ. Ensure the other device is Bluetooth enabled.ī.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |